| AFG-01 |
Adhesives for Field-Gluing Plywood to Wood Framing |
|
| AISI Chapter F |
Tests for Special Cases |
|
| ANSI Z124.1 |
Standard for Plastic Bathtub Units |
|
| ANSI Z124.2 |
Standard for Plastic Shower Units |
|
| ANSI Z124.3 |
Standard for Plastic Lavatory Units |
|
| ANSI Z124.4 |
Standard for Plastic Water Closet Bowls and Tanks |
|
| ANSI Z124.5 |
Standard for Plastic Toilet (Water Closet) Seats |
|
ANSI A225.1
Sec. 3-2.8 |
Anchoring Equipment Testing |
|
ANSI A225.1
Sec. 3-2.8.4 |
Tie Materials Properties Testing |
|
ANSI A225.1
Sec. 3-2.9.1 |
Ground Anchor Capacity Testing |
|
ANSI/TPI 1
Sec. 7.1 |
Standard Methods of Test for Determining Lateral
Resistance Strength of Metal Connector Plate Teeth |
|
ANSI/TPI 1
Sec. 7.2 |
Standard Methods of Test for Strength Properties
of Metal Connector Plates Under Pure Shear Force |
|
ANSI/TPI 1
Sec. 7.3 |
Standard Methods of Test for Strength Properties
of Metal Connector Plates Under Pure Tension Forces |
|
ASCE 7-95
Sec. 4.4 |
Handrail, Guard,
Grab Bar Load Test |
|
| CA 25-4 |
State of California Specification CA 25-4: Standard
for the Evaluation of Adhesives for Structural use
in the manufacture of Mobile homes and Commercial Coaches |
|
| ENERY STAR® |
EPA ENERGY STAR® Labeling Program
for Manufactured Housing |
| • |
Whole House Air Leakage Testing Under Specified
Air Pressure Difference |
| • |
Total Duct Air Leakage Testing Under Specified
Air Pressure Difference |
| • |
Duct Air Leakage (to the Outside) Testing Under
Specified Air Pressure Difference |
| • |
Duct/House Leakage Diagnostics and Troubleshooting |
|
|
| ENERGY STAR® |
EPA ENERGY STAR® Home Energy Rating
System (HERS) Certification for Site-Built and Modular
Residential Structures |
| • |
Whole House Air Leakage Testing Under Specified
Air Pressure Difference |
| • |
Total Duct Air Leakage Testing Under Specified
Air Pressure Difference |
| • |
Duct Air Leakage (to the Outside) Testing Under
Specified Air Pressure Difference |
| • |
Duct/House Leakage Diagnostics and Troubleshooting |
|
|
FMHCSS
24CFR
§3280.103 |
Whole House Ventilation |
|
|
FMHCSS
24CFR
§3280.305 (g)(1) |
Floor Decking Material Concentrated Load Test |
|
FMHCSS
24CFR
§3280.305 (g)(5) |
Bottom Board Puncture Resistance Test (Beach Puncture
Test) |
|
FMHCSS
24CFR
§3280.306 (f) |
Anchoring Equipment Load Resistance Test |
|
FMHCSS
24CFR
§3280.401 |
Structural Load Tests |
| • |
Shear Wall Assembly Ultimate Load Test |
| • |
Cantilever Floor Assembly Ultimate Load Test |
| • |
Plywood Ridge Beam Ultimate Load Test |
| • |
Header Assembly Ultimate Load Test |
| • |
Pier & Pier Pad Ultimate Load Test |
| • |
Concrete Stair Ultimate Load Test |
| • |
Exterior Sheathing Negative Wind Ultimate Pressure
Test |
| • |
Vinyl Siding Negative Wind Ultimate Pressure
Test |
| • |
Interior Partition Ultimate Load Test |
|
|
FMHCSS
24CFR
§3280.402 |
Test Procedure for Roof Trusses |
|
|
|
FMHCSS
24CFR
§3280.403 |
Standard for Windows and Sliding Glass Doors Used
in Manufactured Homes |
| • |
Skylight Assembly Negative Wind Ultimate Pressure
Test |
|
|
|
|
| TAPPI T803 |
Puncture Test of Container Board |
|
| BOCA 1606.4 |
Handrail, Guard,
Grab Bar Load Test |
|
| SBCCI H105.1.2 |
Manufactured Load Bearing Supports or Devices Ultimate
Load Testing |
|
| SBCCI H105.4.5 |
Tie Material Properties Testing |
|
| SBCCI H105.5.2 |
Ground Anchor Capacity Testing |
|
| ASTM D3165 |
Adhesive Shear Testing |
|
| ASCE 7 |
GuardRail and HandRail Testing |
|
| |
Fence Wind Load Testing |
|
| ASTM D3500 |
Structural Panel Tension Test |
|
| ASTM E330, E997 |
Structural Performance of Exterior Windows, Curtain
Walls, Doors by Uniform
Static Air Pressure Difference |
|
| ASTM E283 |
Rate of Air Leakage Through Exterior Windows,
Walls, and Doors Under
Specified Air Pressure Difference |
